Auto Tune 7 goes wacky? Anyone else?

Hey all, Just did some AutoTune graph mode action on a track, created my notes, made my adjustments etc... I save and close REAPER. When I open it again, my notes are all crazy wacked out. For example, I look at the graph and can see that half the notes are being represented like 3 octaves below what they should. I panicked at first, but found a fix, I just need to click, select all in AT7, and then they all pop back to where they should be. Anyone else using AT7 experience this kind of behavior? Is there a way to just fix it entirely? Or must I really banish evil demonic voices(3 octaves down) every time I open a session with AT7? :D

Check on Antares' site but I don't think Autotune is Reaper approved. I have Autotune 4 that definitely doesn't work with it.

DeyBwah, I have At 5 and it works fine for me. I have had some weirdness like that before. What happened was that I rendered the project with the AT effect enabled. What I ususally do, is fix up a section, and then render that as a new take. I listen to make sure it is OK and then, I disable AT. Then when redering the track, all AT is disabled. Your mixdown is using an already rendered track and it should be fine. I think something happens when AT is used during a complete render. It can move the corrections to new spots on the track or something, I don't know. Just get it rendered on the individual track before a mix render.